色综和 I 日韩一区二区免费看 I 国产亚洲精品久久久久久打不开 I 一区视频在线 I 在线视频资源 I 国产国产成人免费c片 I 国产一区二区二 I 久久99精品国产99久久6不卡 I 亚洲aⅴ无码专区在线观看春色 I 日韩亚洲欧美一区二区 I 中文字幕在线观看你懂的 I 9999免费视频 I 欧美三级日韩三级 I 少妇性i交大片免费 I xxx国产精品视频 I 亚洲色大网站www永久网站 I 激情综合激情网 I 97人妻免费公开在线视频 I 男人天堂综合网 I 国产主播福利在线 I 亚洲图片视频在线观看 I 国产无套粉嫩白浆内谢的出处 I 天天操天天碰 I 欧美久久久 I 国产极品一区二区三区 I 老色鬼永久精品网站 I 青青青视频在线免费观看 I 欧美性猛烈xxxx视频少妇少 I 日韩在线播放一区二区三区 I 欧美一区三区

Due to the special structure of plastic surface, although the surface of plastic parts is modified through surface pretreatment, the weak interface layer is removed, the surface of plastic parts is activated, and the adhesion of coating film is increased, the selection of coating, coating process and coating environment management in the manufacturing of mechanical plastic shell will also affect the coating quality.

Therefore, the selection of mechanical plastic shell coating should follow the "similar phase solubility principle", in order to ensure the good miscibility of ABS and coating resin and solvent, make the coating film and plastic surface form a very thin mutually soluble layer, enhance the adhesion, not only have a good decorative effect, but also meet the physical and chemical performance requirements of the paint film.

At present, mechanical plastic shell coating mostly use manual air spraying process, labor intensity, poor working environment, coating efficiency is only about 20% ~ 30%, paint loss, high cost, man-made quality instability factors directly affect the quality of products.

With the development of science and technology, mechanical plastic shell manufacturing industry in the mold coating in the plastic processing development is very fast, that is, the use of electrostatic coating coating in the mold wall, in the plastic molding, at the same time to complete the surface coating of plastic parts. Due to the plastic molding temperature is higher, is conducive to the coating curing, the mold itself roughness is very low, therefore, the coating surface is very clean, high gloss.

After the mechanical plastic shell is moulded, the mold is slightly lifted, injected into IMC at high pressure, the mold is closed at high pressure to make IMC fully expanded, and after hardening, the plastic surface is very smooth, it can get high quality decorative products at a low cost, and the moulded parts can be immediately packaged or sent for assembly, very convenient.

The mechanical plastic shell of these two coating technology coatings are solvent-free, no organic solvents in the process of operation, so there is no environmental pollution, paint utilization rate is very high, to avoid heavy painting, no special coating equipment, when the injection is completed painting.