色综和 I 日韩一区二区免费看 I 国产亚洲精品久久久久久打不开 I 一区视频在线 I 在线视频资源 I 国产国产成人免费c片 I 国产一区二区二 I 久久99精品国产99久久6不卡 I 亚洲aⅴ无码专区在线观看春色 I 日韩亚洲欧美一区二区 I 中文字幕在线观看你懂的 I 9999免费视频 I 欧美三级日韩三级 I 少妇性i交大片免费 I xxx国产精品视频 I 亚洲色大网站www永久网站 I 激情综合激情网 I 97人妻免费公开在线视频 I 男人天堂综合网 I 国产主播福利在线 I 亚洲图片视频在线观看 I 国产无套粉嫩白浆内谢的出处 I 天天操天天碰 I 欧美久久久 I 国产极品一区二区三区 I 老色鬼永久精品网站 I 青青青视频在线免费观看 I 欧美性猛烈xxxx视频少妇少 I 日韩在线播放一区二区三区 I 欧美一区三区

The forging parts are made by mechanical forging and pressing mechanism. Before work, the forging parts should be done carefully. The molds should be in good condition without cracks, installed correctly and fastened firmly. Clean up the debris in the slider travel space and mold space; Will die preheat to 150 ° С ~ 200 ° С left and right sides, and pay attention to preheat before work out.

Before starting the main motor, test the solenoid air valve of the clutch, and confirm that the action of the air valve, clutch and brake is accurate, sensitive and reliable before starting the main motor. The steering of the main motor must be in accordance with the specified direction; Alignment of closing height must be carried out in strict accordance with the alignment procedures and methods stipulated in the specification; Do not switch on the main motor when adjusting the lower charging device.

"Inching" should only be used for the first step stroke of the slider after empty operation test or change of mold or speed adjustment closing height. Its program is: start the main motor for a moment, close the main motor with flywheel inertia, "inching" slider stroke. Check whether the closing height and concentricity of the mold are appropriate, and then use "inching", "one-stroke" and "continuous stroke" in turn to operate according to the working specifications.

Forging press work, prohibit forging temperature below 900 ° С forging parts; When the slider is running, no head or hands are allowed to reach into the closed space of the mold, and no pliers are allowed to reach into the mold to correct or take or place the forging. Also often pay attention to the working of the mold, if found loose phenomenon immediately tighten.

If e excrement needs attention, when the forging blank is put into the mold and the forging is taken out from the mold, it is forbidden to put the foot on the power pedal; The oxide scale on the mold should be cleaned frequently. After work, the slider should be stopped at the upper dead point for the next forging production.